kw.\*:("62.20.de")
Results 1 to 25 of 1027
Selection :
Analysis of ISE in dynamic hardness measurements of β-Sn single crystals using a depth-sensing indentation techniqueSAHIN, O; UZUN, O; KÖLEMEN, U et al.Materials characterization. 2008, Vol 59, Num 6, pp 729-736, issn 1044-5803, 8 p.Article
Vickers microindentation hardness studies of β-Sn single crystalsSAHIN, O; UZUN, O; KOLEMEN, U et al.Materials characterization. 2007, Vol 58, Num 2, pp 197-204, issn 1044-5803, 8 p.Article
Mechanical characterization for β-Sn single crystals using nanoindentation testsSAHIN, O; UZUN, O; KÖLEMEN, U et al.Materials characterization. 2008, Vol 59, Num 4, pp 427-434, issn 1044-5803, 8 p.Article
Negative Poisson's ratio behavior in the planar model of asymmetric trimers at zero temperatureNAROJCZYK, J. W; ALDERSON, A; IMRE, A. R et al.Journal of non-crystalline solids. 2008, Vol 354, Num 35-39, pp 4242-4248, issn 0022-3093, 7 p.Conference Paper
Indentation-induced microhardness changes in glasses : Possible fictive temperature increase caused by plastic deformationGROSS, T. M; TOMOZAWA, M.Journal of non-crystalline solids. 2008, Vol 354, Num 34, pp 4056-4062, issn 0022-3093, 7 p.Article
Application of microstructure sensitive design to structural components produced from hexagonal polycrystalline metalsFAST, Tony; KNEZEVIC, Marko; KALIDINDI, Surya R et al.Computational materials science. 2008, Vol 43, Num 2, pp 374-383, issn 0927-0256, 10 p.Article
On the effect of hydrostatic pressure on the auxetic character of NAT-type silicatesGRIMA, Joseph N; CASSAR, Richard N; GATT, Ruben et al.Journal of non-crystalline solids. 2009, Vol 355, Num 24-27, pp 1307-1312, issn 0022-3093, 6 p.Conference Paper
Microhardness, indentation toughness, elasticity, plasticity, and brittleness of Ge-Sb-Se chalcogenide glassesVARSHNEYA, Arun K; MAURO, Daniel J.Journal of non-crystalline solids. 2007, Vol 353, Num 13-15, pp 1291-1297, issn 0022-3093, 7 p.Conference Paper
Fatigue of highly strengthened Cu-Ag alloysFREUDENBERGER, J; KLASS, H.-J; HEINZE, K et al.International journal of fatigue. 2008, Vol 30, Num 3, pp 437-443, issn 0142-1123, 7 p.Article
Effective elastic properties of interpenetrating phase compositesPONIZNIK, Z; SALIT, V; BASISTA, M et al.Computational materials science. 2008, Vol 44, Num 2, pp 813-820, issn 0927-0256, 8 p.Article
Fatigue crack growth predictions based on damage accumulation calculations ahead of the crack tipPINHO DE CASTRO, Jaime Tupiassú; MEGGIOLARO, Marco Antonio; DE OLIVEIRA MIRANDA, Antonio Carlos et al.Computational materials science. 2009, Vol 46, Num 1, pp 115-123, issn 0927-0256, 9 p.Article
Modeling of the effects of athermal flow strength and activation energy for dislocation glide on the nanoindentation creep of nickel thin film at room temperatureHASEEB, A. S. M. A.Computational materials science. 2006, Vol 37, Num 3, pp 278-283, issn 0927-0256, 6 p.Article
On the nature of the static friction, kinetic friction and creepPERSSON, B. N. J; ALBOHR, O; MANCOSU, F et al.Wear. 2003, Vol 254, Num 9, pp 835-851, issn 0043-1648, 17 p.Conference Paper
Severe plastic deformation and strain localization in groove pressingSEUNG CHAE YOON; KRISHNAIAH, A; CHAKKINGAL, Uday et al.Computational materials science. 2008, Vol 43, Num 4, pp 641-645, issn 0927-0256, 5 p.Article
NanoadhesionPERSSON, B. N. J.Wear. 2003, Vol 254, Num 9, pp 832-834, issn 0043-1648, 3 p.Conference Paper
Crack-free high load Vickers indentation of silica glassGROSS, T. M; TOMOZAWA, M.Journal of non-crystalline solids. 2008, Vol 354, Num 52-54, pp 5567-5569, issn 0022-3093, 3 p.Article
Finite element analysis of auxetic plate deformationSTREK, Tomasz; MARUSZEWSKI, Bogdan; NAROJCZYK, Jakub W et al.Journal of non-crystalline solids. 2008, Vol 354, Num 35-39, pp 4475-4480, issn 0022-3093, 6 p.Conference Paper
Atomistic simulation of Fe-C austeniteOILA, A; BULL, S. J.Computational materials science. 2009, Vol 45, Num 2, pp 235-239, issn 0927-0256, 5 p.Article
Stress exponent investigation of β-Sn single crystal by depth-sensing indentation testsSAHIN, O; UZUN, O; KÖLEMEN, U et al.Physica. B, Condensed matter. 2007, Vol 396, Num 1-2, pp 87-90, issn 0921-4526, 4 p.Article
Numerical characterisation of the relaxation of dislocation systemsCSIKOR, F. F; KOCSIS, B; BAKO, B et al.Materials science & engineering. A, Structural materials : properties, microstructure and processing. 2005, Vol 400-01, pp 214-217, issn 0921-5093, 4 p.Conference Paper
Mechanical study of metallized polyethylene terephthalate (PET) filmsGUPTA, Sandhya; DIXIT, Manasvi; SHARMA, Kananbala et al.Surface & coatings technology. 2009, Vol 204, Num 5, pp 661-666, issn 0257-8972, 6 p.Article
Ab initio investigation of osmium carbideZEMZEMI, M; HEBBACHE, M.International journal of refractory metals & hard materials. 2008, Vol 26, Num 2, pp 61-67, issn 0958-0611, 7 p.Article
Structure and mechanical properties of reactive sputtering CrSiN filmsGUANGAN ZHANG; LIPING WANG; WANG, S. C et al.Applied surface science. 2009, Vol 255, Num 8, pp 4425-4429, issn 0169-4332, 5 p.Article
A study on the electrolytic in-process dressing (ELID) for silica glass in a ductile modeGU, J. Q; LI, D. C; GAO, S. J et al.Journal of non-crystalline solids. 2008, Vol 354, Num 12-13, pp 1398-1400, issn 0022-3093, 3 p.Conference Paper
Forming abilities of monatomic chains of several fcc and bcc metals in different crystallographic orientationsLIU, D; ZHENG, W. T; JIANG, Q et al.Applied surface science. 2005, Vol 252, Num 5, pp 1780-1784, issn 0169-4332, 5 p.Article